User's Manual

358 Using the iKVM Module
My iKVM is tiered through the ACI port
to an external KVM switch, but all of the
entries for the ACI connections are
unavailable.
All of the states are showing a yellow dot
in the OSCAR interface.
The front panel connection is enabled
and has a monitor connected. Because the
front panel has precedence over all other
iKVM connections, the ACI and rear
panel connectors are disabled.
To enable your ACI port connection,
you must first disable front panel access
or remove the monitor connected to the
front panel. The external KVM switch
OSCAR entries become active and
accessible.
To disable the front panel using the
Web interface:
1 Log in to the CMC Web interface.
2 Select iKVM in the system tree.
3 Click the Setup tab.
4 Clear (un-check) the Front Panel
USB/Video Enabled check box.
5 Click Apply to save the setting.
To disable the front panel using
RACADM, open a serial/Telnet/SSH text
console to CMC, log in, and type:
racadm config -g cfgKVMInfo -
o cfgKVMFrontPanelEnable 0
Table 10-6. Troubleshooting iKVM
(continued)
Problem Likely Cause and Solution