User's Manual

Using the CMC Web Interface 147
Table 5-36. IPv4 Settings
Setting Description
Enable IPv4 Allow CMC to use the IPv4 protocol to communicate on
the network. Clearing this box does not prevent IPv6
networking from occurring. Default: Checked (enabled)
DHCP Enable Enables CMC to request and obtain an IP address from
the IPv4 Dynamic Host Configuration Protocol (DHCP)
server automatically. Default: Checked (enabled)
If this option is checked, CMC retrieves
IPv4 configuration (IP Address, subnet mask,
and gateway) automatically from a DHCP server on
your network. CMC always has a unique IP Address
allotted over your network.
NOTE: When this feature is enabled, the Static IP Address,
Static Subnet Mask, and Static Gateway property fields
(located immediately following this option on the Network
Configuration page) are disabled, and any previously entered
values for these properties are ignored.
If this option is not checked, you must manually type the
Static IP Address, Static Subnet Mask, and Static
Gateway in the text fields immediately following this
option in the Network Configuration page.
Static IP Address Specifies the IPv4 address for the CMC Network Interface.
Static Subnet Mask Specifies the static IPv4 subnet mask for the CMC
Network Interface.