User's Manual

Using the CMC Web Interface 143
3 Click the Network tab. The Network Configuration page appears.
4 Enable or disable DHCP for CMC by selecting or clearing the Use DHCP
(For CMC Network Interface IP Address)
check box.
5 If you disabled DHCP, type the IP address, gateway, and subnet mask.
6 Click Apply Changes at the bottom of the page.
Configuring the Network LAN Settings
NOTE: You must have Chassis Configuration Administrator privilege to set up CMC
network settings.
NOTE: The settings on the Network Configuration page, such as community string
and SMTP server IP address, affect both CMC and the external settings of the
chassis.
NOTE: If you have two CMCs (active and standby) on the chassis, and they are
both connected to the network, the standby CMC automatically assumes the
network settings in the event of failover of the active CMC.
To configure the Network LAN settings:
1
Log in to the Web interface.
2 Click the Network tab.
3 Configure the CMC network settings described in Table 5-35 through
Table 5-37.
4 Click Apply Changes .
To configure IP range and IP blocking settings, click the Advanced Settings
button (see "Configuring CMC Network Security Settings" on page 151.)
To refresh the contents of the Network Configuration page, click Refresh.
To print the contents of the Network Configuration page, click Print.