User's Manual

102 Using the RACADM Command Line Interface
While I was using remote
RACADM, the prompt
changed to a ">" and I
cannot get the "$" prompt to
return.
If you type a non-matched double quotation mark (")
or a non-matched single quotation (’) in the command,
the CLI changes to the ">" prompt and queue all
commands.
To return to the "$" prompt, type <Ctrl>–d.
I tried using the following
commands and received an
error saying "Not Found":
$ logout
$ quit
The logout and quit commands are not supported in
the CMC CLI interface.
Table 4-3. Using Serial/ RACADM Commands: Frequently Asked Questions
(continued)
Question Answer