Quick Reference Guide

RACADM Subcommand Details 97

ping6

NOTE: To use this subcommand for CMC you must have Administrator privelege for

CMC and for iDRAC you must have Execute Diagnostic Commands or Configure

iDRAC6 permission.

Synopsis

racadm ping6 <ipv6address>

Examples

racadm iping6 10.9.72.254

IPING6 10.9.72.254 (10.9.72.254): 56 data bytes

64 bytes from 10.9.72.254: icmp_seq=0 ttl=121 time=2.9

--- 10.9.72.254 ping statistics ---

1 packets transmitted, 1 packets received, 0 percent

packet loss

round-trip min/avg/max = 2.9/2.9/2.9 ms

racdump

NOTE: To use this subcommand for CMC you must have Administrator privilege

and for iDRAC you must have Debug permission.

Description

The racdump subcommand provides a single command to get dump, status,

and general iDRAC6 board information.

For CMC, this subcommand displays the comprehensive chassis status and

configuration state information, as well as historic event logs. Used for post

deployment configuration verification and during debugging sessions.

Subcommand Definition

ping6 Verifies that the destination IPv6 address is reachable from iDRAC6

or CMC or with the current routing-table contents. A destination

IPv6 address is required. An ICMP echo packet is sent to the

destination IPv6 address based on the current routing-table contents.