Quick Reference Guide

126 RACADM Subcommand Details
If a failure occurs, the command terminates with an error message that
displays the required corrective action. Use the optional -d switch to obtain
additional diagnostic information, as needed.
testtrap
NOTE: To use this subcommand, you must have Test Alerts permission.
Description
The testtrap subcommand tests the RAC’s SNMP trap alerting feature by
sending a test trap from iDRAC6 to a specified destination trap listener on
the network.
Before you execute the testtrap subcommand, ensure that the specified index
in the RACADM cfgIpmiPet group is configured properly. For more
information, see "cfgIpmiPet" on page 222.
Table 2-43 provides a list and associated commands for the cfgIpmiPet group.
Synopsis
racadm testtrap -i <index>
Table 2-43. cfgEmailAlert Commands
Action Command
Enable the alert racadm config -g cfgIpmiPet -o
cfgIpmiPetAlertEnable -i 1 1
Set the destination
e-mail IP address
racadm config -g cfgIpmiPet -o
cfgIpmiPetAlertDestIpAddr -i 1
192.168.0.110
View the current test
trap settings
racadm getconfig -g cfgIpmiPet -i
<index>
where <index> is a number from 1 to 4