Quick Reference Guide

RACADM Subcommand Details 107
Options
Example
• racadm setled -m server-1 -1 1
LED state was set successfully.
NOTE: The setled command generates an error when used on the extension slot of
a multi-slot server.
• racadm setled -m server-9 -1 1
ERROR: Server in slot 9 is an extension of the
server in slot 1.
setniccfg
NOTE: To use the setniccfg command, you must have Configure iDRAC permission.
Description
The setniccfg subcommand sets iDRAC6 IP address.
•The -d option enables DHCP for the NIC (default is DHCP disabled).
•The
-d6 option enables AutoConfig for the NIC. It is enabled by default.
Table 2-30. setled Subcommand Options
Option Description
-m <module> Specifies the module whose LED you want to configure.
<module> can be one of the following:
• server-n where n =1–16
•
switch-n where n =1–6
• cmc-active
• chassis
-l <ledstate> Specifies whether the LED should blink.
<ledstate> can be one of the following:
• 0 — no blinking
•
1 — blinking