User's Manual

Using the RACADM Command Line Interface 81

To enable/disable the CMC IPv6 addressing, type:

racadm config -g cfgIpv6LanNetworking -o cfgIPv6Enable

NOTE: The CMC IPv6 addressing is disabled by default.

By default, for IPv4, the CMC requests and obtains a CMC IP address from

the Dynamic Host Configuration Protocol (DHCP) server automatically. You

can disable the DHCP feature and specify static CMC IP address, gateway,

and subnet mask.

For an IPv4 network, to disable DHCP and specify static CMC IP address,

gateway, and subnet mask, type:

racadm config -g cfgLanNetworking -o cfgNicUseDHCP 0

racadm config -g cfgLanNetworking -o cfgNicIpAddress

racadm config -g cfgLanNetworking -o cfgNicGateway

racadm config -g cfgLanNetworking -o cfgNicNetmask

By default, for IPv6, the CMC requests and obtains a CMC IP address from

the IPv6 Autoconfiguration mechanism automatically.

For an IPv6 network, to disable the Autoconfiguration feature and specify a

static CMC IPv6 address, gateway, and prefix length, type:

racadm config -g cfgIPv6LanNetworking -o

cfgIPv6AutoConfig 0

racadm config -g cfgIPv6LanNetworking -o

cfgIPv6Address <IPv6 address>

racadm config -g cfgIPv6LanNetworking -o

cfgIPv6PrefixLength 64

racadm config -g cfgIPv6LanNetworking -o

cfgIPv6Gateway <IPv6 address>