User's Manual

408 Troubleshooting and Recovery
Figure 12-1. Password Reset Jumper Location
3 Slide the CMC module into the enclosure. Reattach any cables that
were disconnected.
NOTE: Ensure that the CMC module becomes the active CMC, and remains
the active CMC until the remaining steps are completed.
4 If the jumpered CMC module is the only CMC, then simply wait for it to
finish rebooting. If you have redundant CMCs in your chassis, then
initiate a changeover to make the jumpered CMC module active. Use the
GUI interface to perform the following steps:
Table 12-14. CMC Password Jumper Settings
PASSWORD_RSET (default) The password reset feature is disabled.
The password reset feature is enabled.
PASSWORD_RSET