User's Manual

Using FlexAddress 219
If there are no active features on the chassis, the command returns a message:
racadm feature -s
No features active on the chassis.
Dell Feature Cards may contain more than one feature. Once any feature
included on a Dell Feature Card has been activated on a chassis, any other
features that may be included on that Dell Feature Card cannot be activated
on a different chassis. In this case, the racadm feature -s command displays
the following message for the affected features:
ERROR: One or more features on the SD card are active
on another chassis.
For further information on the RACADM commands, see the feature
and featurecard command sections of the Dell Chassis Management
Controller Administrator Reference Guide.
Deactivating FlexAddress
The FlexAddress feature can be deactivated and the SD card returned to a
pre-installation state using a RACADM command. There is no deactivation
function within the Web interface. Deactivation returns the SD card to
its original state where it can be installed and activated on a different chassis.
NOTE: The SD card must be physically installed in the CMC, and the chassis must
be powered-down before executing the deactivation command.
If you execute the deactivation command with no card installed, or with a
card from a different chassis installed, the feature will be deactivated and no
change will be made to the card.
Deactivating FlexAddress
Use the following RACADM command to deactivate the FlexAddress feature
and restore the SD card:
racadm feature -d -c flexaddress
The command will return the following status message upon successful
deactivation:
feature FlexAddress is deactivated on the chassis
successfully.