User's Manual

Using the CMC Web Interface 205
4 Click the Setup tab, and the FlexAddress subtab. The Deploy FlexAddress
page is displayed. This page allows you to view the WWN configuration
and MAC addresses for the selected server.
The status page presents the following information:
FlexAddress
Enabled
Displays whether the FlexAddress feature is active or not active
for the particular slot.
Current State Displays the current FlexAddress configuration:
• Chassis-Assigned - selected slot address is chassis assigned using
the FlexAddress. The slot-based WWN/MAC addresses remain
the same even if a new server is installed.
•
Server-Assigned - server uses the server-assigned address or the
default address embedded into the controller hardware.
Power State Displays the current power status of the servers; values are: On,
Powering On, Powering Off, Off, and N/A (if a server is not
present).
Health OK Indicates that FlexAddress is present
and providing status to the CMC. In
the event of a communication failure
between the CMC and FlexAddress, the
CMC cannot obtain or display health
status for FlexAddress.
Informational Displays information about FlexAddress
when no change in health status
(OK, Warning, Critical) has occurred.
Warning Indicates that only warning alerts have
been issued, and corrective action must
be taken. If corrective actions are not
taken, then critical failures that can
affect the integrity of the server could
occur.
Critical Indicates that at least one Failure alert
has been issued. Critical status
represents a system failure on the server,
and corrective action must be taken
immediately.
No Value When FlexAddress is absent, health
information is not provided.