User's Manual

144 Using the CMC Web Interface
Static Gateway Specifies the IPv4 gateway for the CMC Network
Interface.
NOTE: The Static IP Address, Static Subnet Mask, and
Static Gateway fields are active only if DHCP Enable (the
property field preceding these fields) is disabled
(unchecked). In that case, you must manually type the Static
IP Address, Static Subnet Mask, and Static Gateway for the
CMC to use over the network.
NOTE: The Static IP Address, Static Subnet Mask, and
Static Gateway fields apply only to the chassis device. They
do not affect the other network-accessible components in
the chassis solution, such as the server network, local
access, I/O modules, and iKVM.
Use DHCP to Obtain
DNS Server Addresses
Obtains the primary and secondary DNS server addresses
from the DHCP server instead of the static settings.
Default: Checked (enabled) by default
NOTE: If Use DHCP (For CMC Network Interface IP Address)
is enabled, then enable the Use DHCP to Obtain DNS Server
Addresses property.
If this option is checked, the CMC retrieves its
DNS IP address automatically from a DHCP server
on your network.
NOTE: When this property is enabled, the Static Preferred
DNS Server and Static Alternate DNS Server property fields
(located immediately following this option on the Network
Configuration page) are inactivated, and any previously
entered values for these properties are ignored.
If this option is not selected, the CMC retrieves the
DNS IP address from the Static Preferred DNS Server and
Static Alternate DNS Server. The addresses of these
servers are specified in the text fields immediately
following this option on the Network Configuration page.
Table 5-36. IPv4 Settings
(continued)
Setting Description