Quick Reference Guide

114 RACADM Subcommands
If a failure occurs, the command terminates with an error message that
displays the required corrective action. Use the optional -d switch to obtain
additional diagnostic information, as needed.
testtrap
NOTE: To use this subcommand, you must have Test Alert User privilege.
Description
Tests the CMC SNMP trap alerting feature by sending a test trap from the
CMC to a specified destination trap listener on the network.
NOTE: This command is valid only if SNMP alerts are enabled on the CMC. For
more information about SNMP alerts, see the "Configuring SNMP and E-mail
Alerting" section in the
Dell Chassis Management Controller User Guide . For
information on enabling and configuring traps, see "cfgTraps".
Usage
racadm testtrap -i <index>
Options
Example
racadm testtrap -i 4
Test trap sent successfully.
traceroute
NOTE: To use this subcommand, you must have Administrator privilege.
Description
Traces a route using IP to a destination on the network.
Table 2-49. testtrap Subcommand Options
Option Description
-i <index> Specifies the index of the trap configuration to use for the test.
Legal values: 1–4