Manualshelf

Users Guide

ManualsBrandsDell ManualsActive System ManagerChassis Management Controller Version 3.0 for Dell PowerEdge VRTX
151152153154155156157158159160
Table Of Contents
Das folgende Beispiel zeigt die Datei mit der neuen Zeile.
# # inittab This file describes how the INIT process # should set up the system in
a certain # run-level. # # Author: Miquel van Smoorenburg # Modified for RHS Linux
by Marc Ewing and # Donnie Barnes # # Default runlevel. The runlevels used by RHS
are: # 0 - halt (Do NOT set initdefault to this) # 1 - Single user mode # 2
- Multiuser, without NFS (The same as 3, if you # do not have networking) # 3 -
Full multiuser mode # 4 - unused # 5 - X11 # 6 - reboot (Do NOT set initdefault
to this) # id:3:initdefault: # System initialization. si::sysinit:/etc/rc.d/rc.sysinit
l0:0:wait:/etc/rc.d/rc 0 l1:1:wait:/etc/rc.d/rc 1 l2:2:wait:/etc/rc.d/rc 2 l3:3:wait:/etc/
rc.d/rc 3 l4:4:wait:/etc/rc.d/rc 4 l5:5:wait:/etc/rc.d/rc 5 l6:6:wait:/etc/rc.d/rc 6 # Things
to run in every runlevel. ud::once:/sbin/update # Trap CTRL-ALT-DELETE ca::ctrlaltdel:/sbin/
shutdown -t3 -r now # When our UPS tells us power has failed, assume we have a few
# minutes of power left. Schedule a shutdown for 2 minutes from now. # This does, of
course, assume you have power installed and your # UPS is connected and working correctly.
pf::powerfail:/sbin/shutdown -f -h +2 "Power Failure; System Shutting Down" # If power
was restored before the shutdown kicked in, cancel it. pr:12345:powerokwait:/sbin/shutdown
-c "Power Restored; Shutdown Cancelled" # Run gettys in standard runlevels co:2345:respawn:/
sbin/agetty -h -L 57600 ttyS1 ansi 1:2345:respawn:/sbin/mingetty tty1 2:2345:respawn:/sbin/mingetty
tty2 3:2345:respawn:/sbin/mingetty tty3 4:2345:respawn:/sbin/mingetty tty4 5:2345:respawn:/
sbin/mingetty tty5 6:2345:respawn:/sbin/mingetty tty6 # Run xdm in runlevel 5 # xdm is now
a separate service x:5:respawn:/etc/X11/prefdm -nodaemon
Edit the /etc/securettyfile as follows:
Fügen Sie eine neue Zeile mit dem Namen des seriellen tty für COM2 hinzu:
ttyS1
Das folgende Beispiel zeigt eine Beispieldatei mit der neuen Zeile.
vc/1 vc/2 vc/3 vc/4 vc/5 vc/6 vc/7 vc/8 vc/9 vc/10 vc/11 tty1 tty2 tty3 tty4 tty5 tty6 tty7
tty8 tty9 tty10 tty11 ttyS1
CMC zur Verwendung von Befehlszeilenkonsolen konfigurieren
157