Release Notes

Known Issues

Topics:

• Different PCIe card device name displayed on the iDRAC and CMC GUIs

• Error occurs while importing CMC configuration file

• Value of power available for server power on increases after PSU failure

• Unable to view chassis logs from remote RACADM

• Static IPv6 IP address can be assigned to iDRAC blades

Different PCIe card device name displayed on the

iDRAC and CMC GUIs

Description PCIe card device name displayed on the iDRAC GUI and CMC GUI is not same for Broadcom/Qlogic 10G card.

Resolution Refer to the iDRAC GUI, it is accurate and current.

Versions/Systems

affected

None

Error occurs while importing CMC configuration

file

Description

An error occurs while importing CMC configuration file using local or remote RACADM.

Resolution This issue occurs when IPv6 is enabled or disabled from the configuration file. Enable or disable IPv6 using the

command, racadm config -g cfgIPv6LanNetworking -o cfgIPv6Enable 0.

Versions/Systems

affected

CMC for PowerEdge FX2 1.10 or later

Value of power available for server power on

increases after PSU failure

Description

The value of "Power Available for Server Power-on” can increase after PSU failure and recovery, without any

changes to the underlying chassis hardware components.

Resolution For actual power consumption of the chassis, in the CMC GUI, go to the Chassis Overview > Power > Power

Monitoring > System Input Power .

Versions/Systems

affected

All versions of FX2/FXs

Unable to view chassis logs from remote RACADM

Description

Unable to view chassis logs from remote RACADM

Resolution None

Use firmware RACADM instead, to view the chassis logs.

14 Known Issues