Release Notes

Fixes

• Fixed an issue causing Internal server error observed while deleting virtual disk.

• Fixed an issue causing FANs are running at 30% PWM across all the interfaces during single-server iDRAC firmware update.

• Fixed an issue causing Unable to set ECC value to raid controller using factory command.

• Fixed an issue causing Internal Server Error while checking the chassis logs.

• Fixed an issue causing LCD orientation getting change to Tower mode after firmware downgrade or upgrade.

• Fixed an issue causing discrepancy in IOM health state when there is fabric mismatch error on IOM.

• Fixed an issue causing Last Post Code status for servers in "Boot F1/F2 prompt" state is incomplete in LCD graphics.

• Fixed an issue causing the FX2 power supply to randomly report a 0v input.

Release 2.21

• Fixed an issue causing memory leak to improve SNMP performance.

• Fixed an issue causing CMC/chassis to enter failsafe mode due to memory leak.

• Fixed an issue causing CMC becomes unresponsive and loses SSH access.

• Applied Linux kernel patches to address new security vulnerabilities.

Release 2.20

• Fixed an issue causing the PLX switches to power off when any sled in the chassis is turned off when PCIe reassignment is enabled.

Release 2.10

• Fixed an issue causing a control panel synchronization failure during CMC firmware update.

• Fixed an issue causing the PCIe adapters to potentially not link at the correct width or speed during sled reset.

Release 2.00

• Fixed an issue causing shutdown of servers in redundancy alert only (RAO) mode during power supply failure.

• Fixed an issue causing continuous rebooting of CMC (version <= 1.3x) with 2400W PSU.

• Fixed an issue causing failure of racresetcfg, when the six RSA-4096 or four RSA-2048, and two 2048 DSA SSH public keys are

uploaded to the CMC.

Release 1.42

• Fixed an issue causing unavailability of a raid license resulting in foreign configuration during a CMC reset.

Release 1.40

• Fixed an issue that caused the Server Profile page to stop responding when a profile is applied to multiple servers.

Release 1.33

• Fixed an issue that occasionally prevented CMC from applying the required Fan PWM after a CMC reset.

Fixes 11