CLI Guide

• -u—User name of the CIFS share that must be tested.
• -p—Password for the CIFS share that must be tested.
• -l—The CIFS share location that must be tested.
Example racadm testcifsshare -u shareme -p shareme -l //100.97.174.77/lccifs
testemail
Table 105. Details of testemail
Description Sends a test e-mail from CMC to a specified destination. Prior to executing the test e-mail
command, make sure that the SMTP server is configured and the specified index in the RACADM
cfgEmailAlert group is enabled and configured properly.
Synopsis
racadm testemail -i <index>
Input -i — Specifies the index of the e-mail alert to test.
Output
Success: Test e-mail sent successfully
Failure: Unable to send test e-mail
Example Commands for the cfgEmailAlert group:
• Enable the alert —
racadm config -g cfgEmailAlert -o cfgEmailAlertEnable -i 1
• Set the destination e-mail address —
racadm config -g cfgEmailAlert -o cfgEmailAlertAddress -i 1
[e-mail]
• Set the custom message that is sent to the destination e-mail address —
racadm config -g cfgEmailAlert -o cfgEmailAlertCustomMsg -i 1
"This is a test!"
• Make sure that the SMTP IP address is configured properly —
racadm config -g cfgRemoteHosts -o cfgRhostsSmtpServerIpAddr
192.168.0.152
• View the current e-mail alert settings —
racadm getconfig -g cfgEmailAlert -i <index>
where <index> is a number from 1 to 4.
testfeature
The following tables describe the testfeature subcommand options.
Table 106. Details of testfeature
Option Description
-f <feature> Specifies the feature name. testfeature supports the following features:
98 RACADM Subcommand Details