CLI Guide

Table 92. Details of setled (continued)
NOTE: The setled command generates an error when used on the extension slot of a
multi-slot server.
• racadm setled -m server-2 -1 1
ERROR: Server in slot 9 is an extension of the server in slot 1.
setniccfg
Table 93. Details of setniccfg
Description Sets the CMC IP address. It displays an error message if the requested operation could not be
performed, or a success message, if the operation is completed successfully.
To use this subcommand, you must have the Configure Chassis Administrator permission.
NOTE: The terms NIC and Ethernet management port may be used interchangeably.
Synopsis • racadm getniccfg
• racadm getniccfg –m <module>,
where –m must be one of the following values:
○ chassis: default state if -m is not specified
○ server-n: where n = 1 to 4
○ switch-n: where n = 1 or 2
• racadm setniccfg -d
• racadm setniccfg -d6
• racadm setniccfg -s <IPv4Address> <netmask> <IPv4 gateway>
• racadm setniccfg -s6 <IPv6 Address> <IPv6 Prefix Length> <IPv6
Gateway>
• racadm setniccfg -o
• racadm setniccfg —p [-6}
• racadm setniccfg [-m <module>] —k [<speed> <duplex>]
• racadm setniccfg [-i <slot>] —v [<vlan_id> <vlan_priority>]
Input
• -d — Enables DHCP for the NIC (default is “DHCP disabled”.)
• -d –6 — Enables AutoConfig for the NIC. It is enabled by default.
• -s — Enables static IP settings. The IPv4 address, netmask, and gateway can be specified.
Otherwise, the existing static settings are used. < IPv4Address >, < netmask >, and < gateway >
must be typed as dot-separated strings.
racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1
• -s –6 — Enables static IPv6 settings. The IPv6 address, Prefix Length, and the IPv6 gateway
can be specified.
• -o — Enable or disable NIC.
• -m<module> — Must be one of the following values:
○ chassis: Default state if - m is not specified.
○ server-n: where n=1–4
○ server-nx: where n=1–4; x=a-d (lower case)
○ switch-n: where n=1–2
• -i <slot> — Must be number n, where n=1 to 4
• -v — When performing on a switch, release and renew any DHCP lease on that port for the
changes to be effective. The VLAN settings must be one of the following legal values:
○ no arguments imply remove vlan tag, not compatible with server-nx. For example
(“server-4b”) notation
RACADM Subcommand Details 87