CLI Guide

ManualsBrandsDell ManualsActive System ManagerChassis Management Controller Version 2.30 For Dell PowerEdge FX2

NOTE: The - (dash) character cannot be the first character of the string, regardless of whether the string is quoted.

There are different escaping rules for double quotation marks.

There are different escaping rules for using single quotation mark and double quotation marks.

For using double quotation marks:

The following characters must be escaped by prepending a backward slash:

• $ (dollar sign)

• " (double quotation mark)

• ' (single quotation marks)

• ` (back quotation mark)

For example, use the following for a string that contains the special characters, $, ",',`and \.

For using single quotation marks:

• No character escaping is necessary.

• A single quotation mark cannot be used even with a backslash escaped.

NOTE: An empty string may be specified as either "" (using double quotation marks) or '' (using single quotation mark).

Question mark and question mark with

subcommand

Table 4. Details of Question mark and question mark with subcommand

Description

Displays all the subcommands you can use with the RACADM command and a one-line description of

each subcommand.

? followed by <subcommand> displays the syntax for the specified command.

To use this subcommand, you must have the CMC Login User privilege.

You can also use the help and help <

subcommand

> commands to obtain the same information.

Synopsis

• racadm ?

• racadm ? <subcommand>

Input NA

Output NA

Example for RACADM ?

The following output example shows only part of the actual output for the racadm ? command. Descriptions shown in this example may

vary slightly from the descriptions in your racadm session.

racadm ?

help -- list racadm subcommand description

help <subcommand> -- display usage summary for a subcommand

? -- list racadm subcommand description

? <subcommand> -- display usage summary for a subcommand

arp -- display the networking arp table

chassisaction -- execute chassis or switch power-up/down/cycle or

clrraclog -- clear the CMC log

clrsel -- clear the System Event Log (SEL)

config -- modify CMC configuration properties

...

setniccfg -- modify network configuration properties

setractime -- set the time on the CMC

setslotname -- sets the name of the slot in the chassis

setsysinfo -- set the chassis name and chassis location

sslcertview -- display a CA/server certificate in the CMC

RACADM Subcommand Details