Users Guide

NOTE: You can perform the Quick Deploy action only if the Action When Server is Inserted option in the Deploy

iDRAC page is set to Server Profile or Quick Deploy then Server Profile. Selecting this option allows you to apply the

server profile assigned when a new server is inserted in the chassis.

2. From the drop-down menu, select the profile to assign to the required slot. You can select profiles to apply to multiple slots.

3. Click Assign Profile.

The profile gets applied to the selected slots.

NOTE: When the FM120x4 sled is inserted, the stored profile assigned to the server slot is applied to all the four servers.

NOTE:

• A slot that does not have any profile assigned to it is indicated by the term "No Profile Selected" that appears in the

select box.

• To remove a profile assignment from one or more slots, select the slots and click Remove Assignment. A message is

displayed warning you that removing a profile from the slot or slots removes the XML configuration settings in the

profile from any servers inserted in the slots when Quick Deploy Profiles feature is enabled. Click OK to remove the

profile assignments.

• To remove all profile assignments from a slot, in the drop-down menu, select No Profile Selected.

NOTE: When a profile is deployed to a server using the Quick Deploy Profile feature, the progress and results of the

application are retained in the Profile Log.

NOTE:

The Network Share option is enabled and the details are displayed in the Stored Profiles section only if the network

share is mounted and is accessible. If the Network Share is not connected, configure the Network Share for the chassis.

To configure the Network Share, click Edit in the Stored Profiles section. For more information, see

Configuring

Network Share Using CMC Web Interface

Boot Identity Profiles

To access the Boot Identity Profiles page in the CMC web interface, in the system tree, go to Chassis Overview > Server Overview.

Click Setup > Profiles. The Server Profiles page is displayed. On the Server Profiles page, click Boot Identity Profiles.

The boot identity profiles contain the NIC or FC settings that are required to boot a server from a SAN target device and unique virtual

MAC and WWN. As these are available across multiple chassis through a CIFS or NFS share, you can quickly and remotely move an

identity from a non-functional server in a chassis to a spare server located in the same or another chassis and thus enabling it to boot with

the operating system and applications of the failed server. The main advantage of this feature is the use of a virtual MAC address pool

that is unique and shared across all chassis.

This feature allows you to manage server operations online without physical intervention if the server stops functioning. You can perform

the following tasks by using the Boot Identity Profiles feature:

• Initial setup

• Create a range of virtual MAC addresses. To create a MAC address, you must have Chassis Configuration Administrator and

Server Administrator privileges.

• Save boot identity profile templates and customize the boot identity profiles on the network share by editing and including the SAN

boot parameters that are used by each server.

• Prepare the servers that use initial configuration before applying their Boot Identity profiles.

• Apply Boot Identity profiles to each server and boot them from SAN.

• Configure one or more spare standby servers for quick recovery.

• Prepare the standby servers that use initial configuration before applying their Boot Identity profiles.

• Use the workload of a failed server in a new server by performing the following tasks:

• Clear the boot identity from the non-functioning server to avoid duplicating the MAC addresses in case the server recovers.

• Apply the boot identity of a failed server to a spare standby server.

• Boot the server with the new Boot Identity settings to quickly recover the workload.

Configuring servers