Users Guide

NOTE: Changes that are made to QuickDeploy fields are immediate, but changes that are made to one or more iDRAC
server network configuration settings may require a couple of minutes to propagate from CMC to iDRAC. Clicking
Refresh early may display only partially correct data for one or more iDRAC servers.
QuickDeploy IP address assignments for servers
The following tables show the way that the QuickDeploy IP addresses assigned to the servers based on the sleds present in the FX2/FX2s
Chassis:
• Two full-width sleds in the chassis:
Figure 3. Two full-width sleds in the chassis
• Four half-width sleds in the chassis:
Figure 4. Four half-width sleds in the chassis
• Eight quarter-width sleds in the chassis:
NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.
Figure 5. Eight quarter-width sleds in the chassis
• Four FM120x4 sleds in the chassis:
NOTE: The Reserved QuickDeploy IPAddresses must be set to 16.
Figure 6. Four FM120x4 sleds in the chassis
• Top row contains only quarter-width sleds and bottom row contains only half-width sleds:
NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.
Figure 7. Quarter-width sleds in top row and half-width sleds in bottom row
• Top row contains only full-width sleds and bottom row contains only half-width sleds:
Figure 8. Full-width sleds in top row and half-width sleds in bottom row
• Top row contains full-width sleds and bottom row contains only quarter-width sleds:
NOTE: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.
78 Configuring servers