Users Guide

For example:
(starting_mac)00:18:8B:FF:DC:FA + (mac_count)0xCF – 1 = (ending_mac)00:18:8B:FF:DD:C8
NOTE: Lock the SD card prior to inserting in the USB Memory Card Reader to prevent accidently modifying any of the
contents. You must unlock the SD card before inserting into CMC.
Verifying FlexAddress activation
To view the FlexAddress feature activation status, run the following RACADM command:
racadm featurecard -s
Feature Name = FlexAddress
Date/time Activated = 05 Oct 2013 - 11:50:49
Feature installed from SD-card serial number = CN0H871T1374036T00MXA00
Feature Name = FlexAddressPlus
Date/time Activated = 05 Oct 2013 - 11:50:49
Feature installed from SD-card serial number = CN0H871T1374036T00MXA00
Feature Name = ExtendedStorage
Current Status = redundant, active
Date/time Activated = 05 Oct 2013 - 11:50:58
Feature installed from SD-card serial number = CN0H871T1374036T00MXA00
If there are no active features on the chassis, the command returns a message: racadm feature -s No features active on the chassis
racadm feature -s
No features active on the chassis
To view the SD card information:
$ racadm featurecard -s
Active CMC:
The feature card inserted is valid, serial number CN0H871T1374036T00MXA00
The feature card contains the following feature(s)
FlexAddress: bound
FlexAddressPlus: bound
ExtendedStorage: bound
Table 25. Status Messages Returned by the featurecard -s Command
Status Message Actions
No feature card inserted.
Check CMC to verify that the SD card was properly inserted.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: bound.
No action required.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: bound to another chassis,
svctag=ABC1234, SD card SN = 1122334455.
Remove the SD card; locate and install the SD card for the current
chassis.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: not bound.
The feature card can be moved to another chassis or can be
reactivated on the current chassis. To reactivate on the current
chassis, enter racadm racreset until the CMC module with the
feature card installed becomes active.
Using FlexAddress and FlexAddress Plus cards 119