CLI Guide

Table 94. Details of setniccfg (continued)

○ server-n: where n=1–4

○ server-nx: where n=1–4; x=a-d (lower case)

○ switch-n: where n=1–2

• -i <slot> — Must be number n, where n=1 to 4

• -v — When performing on a switch, release and renew any DHCP lease on that port for the

changes to be effective. The VLAN settings must be one of the following legal values:

○ no arguments imply remove vlan tag, not compatible with server-nx. For example

(“server-4b”) notation

○ <vlan_id> 1 to 4000, 4021, and 4094 inclusive

○ vlan_priority> 0 to 7, inclusive

• -p — Disables IPV4 (default)/IPV6 protocol

• -k — Must be one of the following legal values:

○ no arguments imply autonegotiate

○ <speed> = 10, 100

○ <duplex> = half, full

• -r — Enable or disable redundant mode. The legal values are:

○ 1 — Enable

○ 0 — Disable

NOTE: The options -o, -k, -p, and -r can be specified for chassis only.

• -6:

○ Sets static IPv6 addresses (w/ -s option).

○ Enables autoconfig for IPv6 (w/ -d option).

○ Disables IPv6 (w/ -p option).

○ Can be specified for chassis or servers.

Example

• racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1

• racadm setniccfg -d

• racadm setniccfg -d6

• Configuration of speed = 100Mbps and duplex= full duplex:

racadm setniccfg -k 100 full

• Configuration of speed and duplex to autonegotiate:

racadm setniccfig -k

• Configuration of redundant mode:

racadm setniccfg -r 1

• Configuration of VLAN id and priority of a slot or all blades in a sleeve:

racadm setniccfg -i 5 -v 1000 7

• Configuration of CMC to a static IPv6 address:

racadm setniccfg -m chassis -s -6 2001:DB8::2 64 2001:DB8::1

• Configuration of server to use stateless autoconfiguration address:

racadm setniccfg -m server-1 -d -6

RACADM Subcommand Details