CLI Guide

Table 80. Details of license (continued)
○ Replace license on a device with a license file on the local file system.
racadm license replace -f License.xml -t 27
○ Replace a storage sled license
racadm license replace -f
nfs/"CfDuqtnJTobaSYGNzmdA4Buz_xyz_dual.xml" -| x.x.x.x:/nfs -
t 8
netstat
Table 81. Details of netstat
Description Displays the routing table and the current connections.
To use this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm netstat
Input
racadm netstat
Output
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
0.0.0.0 100.101.22.1 0.0.0.0 UG
0 0 0 eth0
100.101.22.0 0.0.0.0 255.255.255.0 U 0
0 0 eth0
ping
Table 82. Details of ping
Description Verifies that the destination IP address is reachable from CMC with the current routing-table
contents. A destination IP address is required. An ICMP echo packet is sent to the destination IP
address based on the current routing-table contents.
To use this subcommand for CMC, you must have the Administrator privilege for CMC.
Synopsis
racadm ping <ipaddress>
ping6
Table 83. Details of
Description Verifies that the destination IPv6 address is reachable from a CMC, or with the current routing-table
contents. A destination IPv6 address is required. An ICMP echo packet is sent to the destination
IPv6 address based on the current routing-table contents.
To use this subcommand for CMC, you must have the Administrator privilege.
Synopsis
racadm ping6 <ipv6address>
RACADM Subcommand Details 71