CLI Guide

fanoffset
Table 16. Details of fanoffset
Description
Configures the internal fans to run at a higher speed than the normal speed.
To use this subcommand, you must have the Chassis Configuration Administrator privilege.
Synopsis
racadm fanoffset [-s <off|low|medium|high>
Valid category values are:
• off
• low
• medium
• high
Input s — Sets the fan speed.
Example
• Disable the fanoffset feature.
racadm fanoffset -s off
• Increases fan speed by 20% of fan’s maximum speed. Minimum speed for fan is 35% of the
maximum.
racadm fanoffset -s low
• Increases fan speed by 50% of fan’s maximum speed. Minimum speed for fan is 65% of the
maximum.
racadm fanoffset -s medium
• Sets fans to run at 100% of fan’s maximum speed.
racadm fanoffset -s high
fcp
Table 17. Details of fcp attribute
Description
Prompts you to change the password.
Synopsis
racadm fcp <enable/getstatus>
Input
• enable: Enables the force password change feature
• getstatus: Displays the status of force change password feature
NOTE: You must have the RAC_ADMIN privileges to run the fcp enable command.
Legal Values For the fcp get status, the values are:
• 0 : FCP Feature has been disabled on CMC.
• 1 : FCP Feature has been enabled on CMC.
Example
• To enable force change password feature:
racadm fcp enable
28 RACADM Subcommand Details