CLI Guide

cfgNetTuningNicFullDuplex (Read/Write)
Table 321. Details of cfgNetTuningNicFullDuplex
Description Specifies the duplex setting for the RAC or CMC NIC. This property is used only if the
cfgNetTuningNicAutoNeg is set to 0 (disabled).
Legal Values • 0 (Half Duplex)
• 1 (Full Duplex)
Default 1
cfgNetTuningNicMtu (Read/Write)
Table 322. Details of cfgNetTuningNicMtu
Description The size in bytes of the maximum transmission unit used by CMC NIC.
Legal Values 576 – 1500
Default 1500
NOTE: IPv6 requires a minimum MTU of 1280. If IPv6 is enabled, and cfgNetTuningMtu is set to a lower value, the CMC
uses an MTU of 1280.
cfgNetTuningNicRedunadant
Table 323. Details of cfgNetTuningNicRedunadant
Description Specifies either Stacking or Redundant mode for CMC Management Port 2.
Legal Values • 0 – Stacking
• 1 – Redundant
Default 0 – Stacking
NOTE: When Management Port 2 is set for Redundant but is cabled for Stacking, the downstream CMCs (further from
the top-of-rack switch) will not have a network link.
NOTE: When Management Port 2 is set for Stacking but is cabled for Redundant (two connections to the TOR switch),
routing loops could cause a network storm.
cfgRacSecurity
This group is used to configure settings related to CMC SSL certificate signing request (CSR) feature. The properties in this group
must be configured before generating a CSR from CMC.
Use this object with the config or getconfig subcommands.
To use this object property, you must have Chassis Configuration Administrator privilege.
For more information on generating certificate signing requests, see the subcommand "sslcsrgen."
The following sections provide information about the objects in the cfgRacSecurity group.
CMC Property Database Group and Object Descriptions
153