Users Guide

3. Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC network setting, click Apply

iDRAC Network Settings to deploy the settings to the iDRAC.

The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis. If Set iDRAC Root Password

on Server Insertion and QuickDeploy Enabled are enabled, the user is prompted using the LCD interface to allow or not allow

the password change. If there are network configuration settings that differ from the current iDRAC settings, the user is

prompted to either accept or reject the changes.

NOTE: If there is a LAN or IPMI over LAN difference, the user is prompted to accept the QuickDeploy IP address

setting. If the difference is the DHCP setting, the user is prompted to accept the DHCP QuickDeploy setting.

To copy the QuickDeploy settings into the iDRAC Network Settings section, click Auto-Populate Using QuickDeploy

Settings. The QuickDeploy network configurations settings are copied into the corresponding fields in the iDRAC Network

Configuration Settings

table.

NOTE: Changes made to QuickDeploy fields are immediate, but changes made to one or more iDRAC server

network configuration settings may require a couple of minutes to propagate from CMC to iDRAC. Clicking Refresh

early may display only partially correct data for one or more iDRAC servers.

Assigning QuickDeploy IP Address to Servers

The figure here shows the QuickDeploy IP addresses assignment to the servers when there are four half-height servers in VRTX

chassis:

The following figure shows the QuickDeploy IP addresses assignment to the servers when there are two full-height blades in VRTX

chassis:

Modifying iDRAC Network Settings for Individual Server iDRAC

Using this feature, you can configure the iDRAC network configurations settings for each installed server. The initial values displayed

for each of the fields are the current values read from the iDRAC. To use this feature, you must have an Enterprise License.

To modify the iDRAC Network Settings:

1. In the left pane, click Server Overview, and then click Setup. On the Deploy iDRAC page the iDRAC Network Settings

section lists the iDRAC IPv4 and IPv6 network configuration settings of all the installed servers.

2. Modify the iDRAC network settings as required for the server(s).

NOTE: You must select the Enable LAN option to specify the IPv4 or IPv6 settings. For information about the fields,

see the

Online Help

3. To deploy the setting to iDRAC, click Apply iDRAC Network Settings. Any changes made to the QuickDeploy Settings are

also saved.