Release Notes

 In fault-tolerant (Redundant) mode, the controller associated with virtual disks or physical disk drives is the
active controller.
 When saving Server Profile under "Server Overview > Setup > Profiles", the list of characters that are not
supported for the Profile Name include the characters hash(#), comma(,), and question mark(?).
 You may see an impact in the performance of the Graphical User Interface with this release of CMC. The
performance impact varies by configuration, GUI page, and system load.
 Microsoft Windows Server 2012, Windows Server 2008 R2, Windows 7 do not support TLS 1.2 and TLS 1.1.
Install update below to enable TLS 1.2 and TLS 1.1 as a default secure protocols in WinHTTP in Windows. For
details, see the Microsoft knowledge base article 3140245 at
support.microsoft.com .
 Supports LDAP authentication with OPEN-DS. OPEN-DS must have DH key larger than 768 bits.
Known Issues
Issue 1:
Description
The Asset Name field in the internal enclosure reverts to the original name after a chassis power cycle.
Resolution
None. The Asset Name field is display only and cannot be set.
Versions/Systems Affected
All CMC versions up to CMC 2.12 for Dell PowerEdge VRTX.
Issue 2:
Description
XWKGY_Intel10G card shows Flex disabled address after racresetcfg of CMC in Network Device page and OS.
Resolution
Virtual reseat or Physical reseat of the server.
Versions/Systems Affected
All CMC versions including CMC 2.20 for Dell PowerEdge VRTX and PowerEdge servers with iDRAC7 or earlier.
Issue 3:
Description
After Shared PERC8 controller update, RAID related operations may take longer to report status.