Reference Guide

ManualsBrandsDell ManualsActive System ManagerChassis Management Controller Version 2.20 for Dell PowerEdge VRTX

NOTE: To use this subcommand, you must have the CMC Login User privilege.

Synopsis

raid get controllers -o

Input

• -o — The -o is used to display the fault-tolerant status of a RAID controller.

Example Sample output of a CMC in which either fault-tolerant mode is not available or is not enabled.

RAID.ChassisIntegrated.1-1

Status = Ok

RollupStatus = Ok

Name = Shared PERC8 (Embedded)

FirmwareVersion = 23.8.3-0027

DriverVersion = 06.802.11.00

RebuildRate = 30 %

BgiRate = 35 %

CheckConsistencyRate = 40 %

ReconstructRate = 30 %

PatrolReadRate = 30 %

PatrolReadMode = Manual

PatrolReadState = Stopped

CheckConsistencyMode = Stop On Error

LoadBalanceSetting = Disabled

CopybackMode = OFF

PreservedCache = Not Present

CacheMemorySize = 1024 MB

PersistHotspare = Disabled

SpindownUnconfiguredDrives = Disabled

SpindownHotspare = Disabled

Timeintervalforspindown = 30 (Minutes)

SecurityStatus = Unknown

EncryptionMode = None

SasAddress = 0x590B11C02620E600

PciDeviceId = 0x2f

PciSubdeviceId = 0x1f3e

PciVendorId = 0x1000

PciSubvendorId = 0x1028

PciBus = 0x0

PciDevice = 0x0

PciFunction = 0x0

BusWidth = Unknown

SlotLength = Short

SlotType = Unknown

CapableSpeeds = 6.0 Gb/s, 3.0 Gb/s

LearnMode = Not supported

HighAvailabilityMode = None

PeerController = N/A

Sample output of a CMC in which you have rmware support for the fault-tolerant mode and the

hardware, and fault-tolerant mode is active.