Reference Guide

Example
racadm getconfig -g cfgCurrentIPv6LanNetworking
# cfgCurrentIPv6Enabled=1
# cfgCurrentIPv6AutoConfigWasUsed=1
# cfgCurrentLinkLocalAddress=fe80::21e:4fff:fe1f:5371/64
# cfgCurrentIPv6Address1=2009:123::e48f:9dd8:6f51:a669/64
# cfgCurrentIPv6Address2=fd88:1::21e:4fff:fe1f:5371/64
# cfgCurrentIPv6Address3=fd88:2::21e:4fff:fe1f:5371/64
# cfgCurrentIPv6Gateway=fe80::21c:23ff:fe77:6215
# cfgCurrentIPv6DNSServersFromDHCP6=1
# cfgCurrentIPv6DNSServer1=2009:123::1
# cfgCurrentIPv6DNSServer2=::
cfgNetTuning
This group enables users to congure the advanced network interface parameters for the RAC NIC or CMC. When congured, the
updated settings may take up to a minute to become active.
The following sections provide information about the objects in the cfgNetTuning group.
CAUTION: Use extra precaution when modifying properties in this group. Inappropriate modication of the properties in
this group can result in your RAC NIC become inoperable.
cfgNetTuningNicSpeed
Description
Species the speed for the CMC NIC. This property is used only
if cfgNetTuningNicAutoNeg is set to 0.
Legal Values 10, 100, or 1000
Default 100
cfgNetTuningNicFullDuplex (Read/Write)
Description
Species the duplex setting for the RAC or CMC NIC. This
property is used only if the cfgNetTuningNicAutoNeg is set to 0
(disabled).
Legal Values
• 0 (Half Duplex)
• 1 (Full Duplex)
Default 1
cfgNetTuningNicMtu (Read/Write)
Description
The size in bytes of the maximum transmission unit used by
CMC NIC.
Legal Values 576 – 1500
Default 1500
NOTE: IPv6 requires a minimum MTU of 1280. If IPv6 is enabled, and cfgNetTuningMtu is set to a lower value, the CMC
uses an MTU of 1280.
161