Reference Guide

NOTE: When the FlexAddress and FlexAddressPlus features are active, deactivating one of them
results in deactivation of the other feature also. However, ExtendedStorage is not affected by the
deactivation of FlexAddress or FlexAddresPlus.
● -r — Repair damaged/unformatted ExtendedStorage media.
NOTE: The –r switch requires that the ExtendedStorage feature be deactivated.
CAUTION: Using the -r switch reformats the SD media in the active CMC cardslot. Any
existing ExtendedStorage data will be lost.
● -c — <featurename> must be one of the following:
● flexaddress (with -d)
● flexaddressplus (with -d) ExtendedStorage (with -d or -r)
featurecard
Description
Verifies proper SD card installation and displays the SD card
status.
To use this subcommand, you must have the Chassis
Configuration Administrator privilege.
Synopsis
racadm featurecard -s
Input -s — Lists active SD card features and SD card status.
Output
An example of output is given here.
racadm featurecard -s
Active CMC: The feature card
inserted is valid, serial number =
CN0H871T137401112222A00 The feature card
contains the following feature(s):
FlexAddress: bound
FlexAddressPlus: bound
ExtendedStorage: bound
Standby CMC: The feature card contains
the following feature(s):
FlexAddress: not bound
FlexAddressPlus: not bound
ExtendedStorage: bound
fwupdate
Description
Allows you to update the firmware on the active and standby CMC firmware, chassis infrastructure
firmware, and storage component firmware (RAID controller, hard disk drive, and expander). You can:
● Check the firmware update process status.
● Update the firmware from a FTP or a TFTP server by providing an IP address and optional path.
● Update the firmware from the local file system using remote RACADM.
● The subcommand updates one or more devices of a single type at a time.
To use this subcommand, you must have the Chassis Configuration Administrator privilege.
NOTE:
RACADM Subcommand Details 33