Reference Guide

Introduction
This document provides information about the RACADM subcommands, supported RACADM interfaces, and property database
groups and object definitions of CMC for PowerEdge VRTX.
Topics:
• What’s New in This Release
• Supported RACADM Interfaces
• RACADM Syntax Usage
• Supported RACADM Subcommands
• Other Documents You May Need
• Accessing support content from the Dell EMC support site
What’s New in This Release
● Added the cfgQuickDeploy group.
● Added the cfgTrapsSNMPv3UserId and cfgTrapsSNMPv3UserName to the cfgTraps group.
● Added the cfgUserAdminSNMPv3Enable, cfgUserAdminSNMPv3AuthenticationType, and
cfgUserAdminSNMPv3PrivacyType to the cfgUserAdmin group.
● Added the cfgChassisACPowerRecoveryDisable command to the cfgChassisPower group.
● Added the cfgRacTuneFipsModeEnable and cfgRacTuneTLSProtocolVersionEnable property to the
cfgRacTuning group.
● Added the cfgOobSnmpProtocol and cfgOobSnmpTrapFormat properties to the cfgOobSnmp group.
● Added the vdinit and secure options to the createvd command.
● Added the following options to the raid command:
○ createsecuritykey
○ modifysecuritykey
○ deletesecuritykey
○ encryptvd
○ cryptographicerase
○ unlock
Supported RACADM Interfaces
The RACADM command-line utility provides a scriptable interface that allows you to remotely configure your Chassis
Management Controller (CMC). The utility runs on the management station and the managed system. It is available on the
Dell OpenManage Systems Management and Documentation DVD or at support.dell.com.
The RACADM utility supports the following interfaces:
● SSH or Telnet — Also referred as Firmware RACADM, is accessible by logging in to CMC using SSH or telnet. You do not
have to specify the CMC IP, user name or password to run Firmware RACADM commands.
● Remote — Supports executing RACADM commands from a remote management station such as a laptop or desktop. You
must install the DRAC Tools utility from the OpenManage software on the remote computer to run Remote RACADM
commands. To execute Remote RACADM commands, you must formulate the command such as a an SSH/Telnet RACADM
command except that you must also use the –r –i options or the –r –u –p options. For more information about these
options, see the "RACADM Subcommand Details."
1
12 Introduction