Reference Guide

• Reset server 1.

racadm racreset -m server-1

• Reset servers 1 and 3.

racadm racreset -m server-1 -m server-3

racresetcfg

Description Resets CMC configuration to factory default settings.

NOTE: To use this, you must have the Chassis Administrator privilege.

Synopsis

racadm racresetcfg [-m <module>] [-c <feature>]

Input

• -m : <module> — Must be one of the following values:

– chassis — default state, if -m is not specified.

– server-n, where n=1–4

– switch-n, where n=1

• -c : <feature> — Must be one of the following values:

– ad — Reset Active Directory properties to the default value. The default setting is

“disabled”.

– pcap — Reset Power Cap properties to the default value.

– flex — Reset FlexAddress properties to the default value. The default setting is

“enabled”.

– dpse — Reset Dynamic Power Supply Engagement to the default value. The

default setting is “disabled”.

NOTE: The –c option is valid with only <module=chassis>.

Example

• Perform reset of configuration data to defaults for server-1 module

racadm racresetcfg -m server-1

• Perform reset of power cap feature.

racadm racresetcfg -c pcap

• Perform reset of configuration data to default for switch-1 module

racadm racresetcfg -m switch-1

racresetpcie

Description Resets the PCIe blade mapping in the chassis to factory defaults.

NOTE:

• To use this subcommand for CMC, you must have the Chassis

Administrator privilege.

• This command cannot run successfully, if any blade server is

powered on.

Synopsis

racadm racresetpcie