Reference Guide

• Clear all available alert settings:

racadm eventfilters set -c cmc.alert.all -n none

• Configure using severity as a parameter. For example, all informational

events in storage category are assigned poweroff as action, and email and

snmp as notifications:

racadm eventfilters set -c cmc.alert.storage.info -n

email,snmp

• Configure using subcategory as a parameter. For example, all

configurations under the licensing subcategory in the audit category are

assigned poweroff as action and all notifications are enabled:

racadm eventfilters set -c cmc.alert.audit.lic -n all

• Configure using subcategory and severity as parameters. For example, all

Information events under the licensing subcategory in the audit category

are assigned poweroff as action and all notifications are disabled:

racadm eventfilters set -c cmc.alert.audit.lic.info -

n none

• Configure the event generation interval for temperature statistics:

racadm eventfilters set -c

cmc.alert.system.tmps.warning -r 10

• Configure the event generation interval and notifications for temperature

statistics:

racadm eventfilters set -c cmc.alert.system.tmps -r 5 -

n snmp

fanoffset

Description

Configures the internal fans to run at a higher speed than the normal speed.

To use this subcommand, you must have the Chassis Configuration

Administrator privilege.

Synopsis

racadm fanoffset [-s <off|low|medium|high>

Valid category values are:

• off

• low

• medium

• high

Input s — Sets the fan speed.

Example

• Disable the fanoffset feature.

racadm fanoffset -s off

• Increases fan speed by 20% of fan’s maximum speed. Minimum speed for

fan is 35% of the maximum.

racadm fanoffset -s low

• Increases fan speed by 50% of fan’s maximum speed. Minimum speed for

fan is 65% of the maximum.

racadm fanoffset -s medium

• Sets fans to run at 100% of fan’s maximum speed.

racadm fanoffset -s high