Users Guide

• cfgRacTuning
• cfgRemoteHosts
• cfgSerial
• cfgSessionManagement
For more information about the property default values and ranges, see the Dell Integrated Dell Remote Access Controller (iDRAC)
RACADM Command Line Reference Guide and Chassis Management Controller for PowerEdge FX2/FX2s RACADM Command Line
Reference Guide available at dell.com/support/manuals.
Conguring iDRAC VLAN tag settings
VLANs are used to allow multiple virtual LANs to co-exist on the same physical network cable and to segregate the network trac for
security or load management purposes. When you enable the VLAN functionality, each network packet is assigned a VLAN tag. VLAN tags
are chassis properties. They remain with the chassis even when a component is removed.
NOTE: The iDRAC VLAN settings from CMC are eective only when iDRAC NIC selection is set on the iDRAC for Chassis
(dedicated) LOM mode.
NOTE: The VLAN ID congured using CMC is applied to iDRAC only when iDRAC is in dedicated mode. If iDRAC is in shared
LOM mode, the VLAN ID changes made in iDRAC are not displayed on the CMC GUI.
Conguring iDRAC VLAN tag settings using web interface
To congure VLAN for server:
1 Go to any of the following pages:
• In the left pane, click Chassis Overview > Network > VLAN.
• In the left pane, click Chassis Overview > Server Overview and click Setup > VLAN.
2 On the VLAN Tag Settings page, in the iDRAC section, enable VLAN for the servers, set the priority and enter the ID. For more
information about the elds, see the CMC for Dell PowerEdge FX2/FX2s Online Help.
3 Click Apply to save the settings.
Conguring iDRAC VLAN tag settings using RACADM
• Specify the VLAN ID and priority of a particular server with the following command:
racadm setniccfg -m server-<n> -v <VLAN id> <VLAN priority>
The valid values for <n> are 1–4.
The valid values for <VLAN> are 1–4000 and 4021–4094. Default is 1.
The valid values for <VLAN priority> are 0–7. Default is 0.
For example:
racadm setniccfg -m server-1 -v 1 7
For example:
• To remove a server VLAN, disable the VLAN capabilities of the specied server's network:
racadm setniccfg -m server-<n> -v
The valid values for <n> are 1–16.
Conguring
servers 87