Users Guide
Setting Description
iDRAC IPv6 Prex Length Species the prex length to be assigned for the IPv6 addresses on the iDRAC. The
default value is 64.
Use CMC DNS Settings Enables the CMC DNS Server settings ( IPv4 and IPv6) that are propagated to iDRAC
when a blade server is inserted in the chassis.
3 Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC network setting, click Apply iDRAC
Network Settings to deploy the settings to the iDRAC.
The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis.
To copy the QuickDeploy settings into the iDRAC Network Settings section, click Auto-Populate Using QuickDeploy Settings. The
QuickDeploy network congurations settings are copied into the corresponding elds in the
iDRAC Network Conguration Settings
table.
NOTE: Changes made to QuickDeploy elds are immediate, but changes made to one or more iDRAC server network
conguration settings may require a couple of minutes to propagate from CMC to iDRAC. Clicking Refresh early may display
only partially correct data for one or more iDRAC servers.
QuickDeploy IP address assignments for servers
The following tables show the way that the QuickDeploy IP addresses assigned to the servers based on the sleds present in the FX2/FX2s
Chassis:
• Two full-width sleds in the chassis:
Figure 3. Two full-width sleds in the chassis
• Four half-width sleds in the chassis:
Figure 4. Four half-width sleds in the chassis
• Eight quarter-width sleds in the chassis:
NOTE
: The Reserved QuickDeploy IPAddresses must be set to a minimum of 8.
Figure 5. Eight quarter-width sleds in the chassis
• Four FM120x4 sleds in the chassis:
NOTE
: The Reserved QuickDeploy IPAddresses must be set to 16.
Figure 6. Four FM120x4 sleds in the chassis
Conguring
servers 85