Users Guide

fan sub-graphic. The text hint provides additional information about a fan. Click the fan sub-graphic to view the fan information in the

right pane.

2 Go to Chassis Overview > Fans.

The Fans Status page provides the status, speed measurements in revolutions per minute (RPMs), and threshold values of the fans in

the chassis. There can be one or more fans.

NOTE: In the event of a communication failure between CMC and the fan unit, CMC cannot obtain or display the health

status for the fan unit.

NOTE: The following message is displayed when both the fans are not present in the slots or if a fan is rotating at a low

speed:

Fan <number> is less than the lower critical threshold.

For more information, see the Online Help.

Conguring fans

Fan Oset — This feature allows you to increase the airow delivery to the PCIe card slots. An example usage of the Fan Oset is when

you use high-power or custom PCIe cards that require more cooling than normal. The Fan Oset feature has options of O, Low, Medium,

and High. These settings correspond to a fan speed oset (increase) of 20%, 50%, and 100% of the maximum speed respectively. There is

also minimum speed setup for each option, which is 35% for Low, 65% for Medium, and 100% for High. However, based on the

conguration, the minimum speeds for the Low, Medium, and High options could be higher than these values.

Using the Medium Fan Oset setting for example, increases the speed of fans by 50% of its maximum speed. The increase is above the

speed already set by the system for cooling based on the installed hardware conguration.

With any of the Fan Oset options enabled, the power consumption is increased. The system is louder with the Low oset, noticeably

louder with the Medium oset, and signicantly louder with the High oset. When the Fan Oset option is not enabled, the fan speeds are

reduced to the default speeds required for system cooling for the installed hardware conguration.

To set the oset feature, go to Chassis Overview > Fans > Setup. On the Advanced Fan Conguration page, from the Value drop-down

list corresponding to Fan Oset, select appropriately.

For more information about the Fan Oset feature, see the Online Help.

For setting up these features by using RACADM commands, user the following command:

racadm fanoffset [-s <off|low|medium|high>]

Viewing front panel properties

To view the front panel properties:

1 In the left pane, click Chassis Overview > Front Panel.

2 On the Properties page, you can view the following:

• Power Button Properties

• KVM Properties

• Front Panel Indicators

Viewing KVM information and health status

To view the health status of the KVMs associated with the chassis, do any of the following:

Click Chassis Overview > Front Panel.

Viewing chassis information and monitoring chassis and component health