Users Guide

Using VLAN Manager

You can assign or view the VLAN settings on the IOMs by using the VLAN Manager option.

NOTE: This feature is supported only on Dell PowerEdge I/O Aggregator.

After the mode of the I/O Aggregator is changed to standalone from stacking, remove the startup conguration and reload the I/O

Aggregator. You need not save the system conguration while reloading the I/O Aggregator.

Topics:

• Assigning VLAN to IOM

• Conguring VLAN settings on IOMs using CMC web interface

• Viewing the VLAN settings on IOMs using CMC web interface

• Viewing the current VLAN settings on IOMs using CMC web interface

• Removing VLANs for IOMs using CMC web interface

• Updating untagged VLANs for IOMs using CMC web interface

• Resetting VLANs for IOMs using CMC web interface

Assigning VLAN to IOM

Virtual LAN (VLAN) for IOMs allows you to separate users into individual network segments for security and other reasons. By using

VLANs you can isolate the networks for individual users on a 32 port switch. You can associate selected ports on a switch with selected

VLAN and treat these ports as a separate switch.

CMC Web Interface allows you to congure the in-band management ports (VLAN) on the IOMs.

To assign a VLAN to an IOM, go to Chassis Overview > I/O Module Overview > Setup > VLAN Manager.

In the VLAN Assignment section, select the I/O Module and choose the type of conguration. Also specify the port range and the slot.

Change or edit the VLANs by selecting from the list in the drop-down menu.

Conguring VLAN settings on IOMs using CMC web

interface

To congure the VLAN settings on IOM(s) using the CMC Web interface:

1 Go to I/O Module Overview and click Setup VLAN Manager.

The VLAN Manager page displays the IOM(s) that are turned on and the available ports.

2 In the Select I/O Module section, select the conguration type from the drop down list, and then select the required IOM(s).

3 In the Specify Port Range section, select the range of fabric ports to be assigned to the selected IOM(s).

4 Select the Select or Deselect All option to apply the changes to all or no IOMs.

Select the check box for the specic slots to select the required IOMs.

146 Using VLAN Manager