Users Guide

Conguring network settings for IOM using CMC web
interface
To congure the network settings for I/O Module:
1 In the left pane, click Chassis Overview, click I/O Module Overview, and then click Setup. Alternatively, to congure the network
settings of the available I/O modules that is A1 and A2, click A1 Gigabit Ethernet or A2 Gigabit Ethernet, and then click Setup.
On the Congure I/O Module Network Settings page, type appropriate data, and then click Apply.
2 If allowed, type the root password, SNMP RO Community string, and Syslog Server IP Address for the IOM. For more information
about the eld descriptions, see the Online Help.
NOTE: The IP address set on the IOM from CMC is not saved to the permanent startup conguration of the switch. To
permanently save the IP address conguration, you must run the connect switch command, or racadm connect
switch RACADM command, or use a direct interface to the IOM GUI to save this address to the startup conguration le.
NOTE: The length of the SNMP community string can be in the ASCII value range of 33–125 characters.
3 Click Apply.
The network settings are congured for the IOM.
NOTE: If allowed, you can reset the VLANs, network properties, and IO ports to its default conguration
values.
Conguring network settings for IOM using RACADM
To congure the network settings for an IOM by using RACADM, set the date and time. See the deploy command section in the Dell
Chassis Management Controller for PowerEdge FX2/FX2s RACADM Command Line Reference Guide
.
You can set the user name, password, and SNMP string for the IOM using the RACADM deploy command:
racadm deploy -m switch -u <username> -p <password>
racadm deploy -m switch -u -p <password> -v SNMPv2 <snmpCommunityString> ro
racadm deploy -a [server|switch] -u <username> -p <password>
Viewing Input Output module uplink and downlink
status using web interface
NOTE
: This feature is available only in PowerEdge FX2/FX2s.
You can view the uplink and downlink status information for Dell PowerEdge M I/O Aggregator using the CMC Web interface. To do this:
1 Go to Chassis Overview > I/O Module Overview.
All the IOMs (1–2) appear in the expanded list.
2 Click the IOM (slot) you want to view.
The I/O Module Status page specic to the IOM slot is displayed. The I/O Module Uplink Status and I/O Module Downlink Status
tables are displayed. These tables display information about the downlink ports (1-8) and uplink ports (9-12). For more information, see
the CMC for Dell PowerEdge FX2/FX2s Online Help.
142
Managing Fabrics