User's Manual

ManualsBrandsDell ManualsSoftwareDell Chassis Management Controller Version 2.1

96 Using the RACADM Command Line Interface

While I was using remote RACADM,

the prompt changed to a ">" and I

cannot get the "$" prompt to return.

If you type a double quotation mark (") in the

command, the CLI will change to the ">"

prompt and queue all commands.

To return to the "$" prompt, type <Ctrl>–d.

I tried using the following

commands and received an error

saying "Not Found":

$ logout

$ quit

The logout and quit commands are not

supported in the CMC CLI interface.

Table 4-3. Using the Serial and RACADM Commands: Frequently Asked

Questions

(continued)

Question Answer