User's Manual

Using the RACADM Command Line Interface 93
cfgNicGateway=10.35.10.1
This file will be updated as follows:
#
# Object Group "cfgLanNetworking"
#
[cfgLanNetworking]
cfgNicIpAddress=10.35.9.143
# comment, the rest of this line is ignored
cfgNicGateway=10.35.9.1
The command racadm config -f <
myfile >.cfg parses the file and
identifies any errors by line number. A correct file will update the proper
entries. Additionally, you can use the same getconfig command from the
previous example to confirm the update.
Use this file to download company-wide changes or to configure new systems
over the network with the command, racadm getconfig -f
<
myfile >.cfg.
NOTE: "Anchor" is a reserved word and should not be used in the .cfg file.
Using RACADM to Configure Properties on iDRAC
RACADM config/getconfig commands support the -m <module> option
for the following configuration groups:
cfgLanNetworking
cfgIPv6LanNetworking
cfgRacTuning
cfgRemoteHosts
cfgSerial
cfgSessionManagement