User's Manual

Troubleshooting and Recovery 365
1 Press in the CMC release latch on the handle and rotate the handle away
from the module front panel. Slide the CMC module out of the enclosure.
NOTE: Electrostatic discharge (ESD) events can harm electronic components
inside your equipment. Under certain conditions, ESD may build up on your body or
an object, and then discharge into another object, such as your CMC. To prevent
ESD damage, you should discharge static electricity from your body before you
interact with any of your equipment’s internal electronic components.
2 Remove the jumper plug from the password reset connector, and insert a
2-pin jumper to enable the default administrator account. See Figure 11-1
to locate the password jumper on the CMC board.
Figure 11-1. Password Reset Jumper Location
Table 11-15. CMC Password Jumper Settings
PASSWORD_RSET (default) The password reset feature is disabled.
The password reset feature is enabled.
PASSWORD_RSET