User's Manual

Troubleshooting and Recovery 353

Resetting Components

The Reset Components page allows users to reset the active CMC, or to

virtually reseat servers causing them to behave as if they were removed and

reinserted. If the chassis has a standby CMC, resetting the active CMC will

cause a failover and the standby CMC will become active.

NOTE: To reset components, you must have Debug Command Administrator

privilege.

To access the

Diagnostic Console

page:

Click

Chassis

in the system tree.

Table 11-11. Supported Diagnostic Commands

Command Result

arp Displays the contents of the address resolution protocol (ARP)

table. ARP entries may not be added or deleted.

ifconfig Displays the contents of the network interface table.

netstat Prints the contents of the routing table.

ping <IP address> Verifies that the destination <IP address> is reachable from

the CMC with the current routing-table contents. You must

type a destination IP address in the field to the right of this

option. An Internet control message protocol (ICMP) echo

packet is sent to the destination IP address based on the

current routing-table contents.

gettracelog Displays the trace log (may take a few seconds to display the

log). The gettracelog -i command returns the number of

records in the trace log.

NOTE: For more information about the gettracelog command,

see the gettracelog command section in the Dell Chassis

Management Controller Administrator Reference Guide.