User's Manual

Troubleshooting and Recovery 335
b Enter the desired originator e-mail for the alert, or leave it blank to
use the default e-mail originator. The default is cmc@[IP_address]
where [IP_address] is the IP address of the CMC. If you choose to
enter a value, the syntax of the e-mail name is emailname[@domain],
and an e-mail domain can be optionally specified. If @domain is not
specified and there is an active CMC network domain, then the e-mail
address of [e-mail] is used as the source e-mail.
If @domain is not specified and CMC has no active network domain,
then the IP address of the CMC is used (for example,
emailname@[IP_address]).
c Click Apply to save your changes.
7 Specify the e-mail address(es) that will receive the alerts:
a Type a valid e-mail address in an empty Destination Email
Address
field.
b Enter an optional Name . This is the name of the entity receiving the
e-mail. If a name is entered for an invalid e-mail address, it is ignored.
c Click Apply to save your settings.
To send a test e-mail to an e-mail alert destination:
1
Log in to the CMC Web interface.
2 Select Chassis in the system tree.
3 Click the Alert Management tab. The Chassis Events page appears.
4 Click the Email Alert Settings sub-tab. The Email Alert Destinations
page displays.
5 Click Send in the Destination Email Address column beside the
destination.
Using RACADM
1 Open a serial/Telnet/SSH text console to the CMC and log in.
2 Enable alerting by typing:
racadm config -g cfgAlerting -o cfgAlertingEnable 1
NOTE: Only one filter mask may be set by both SNMP and e-mail alerting.
You may skip step 3 if you have already set a filter mask.