User's Manual

I/O Fabric Management 325
NOTE: Only IOMs that are powered on can be configured.
NOTE: The IP address set on the IOMs from the CMC is not saved to the switch's
permanent startup configuration. To save the IP address configuration
permanently, you must enter the connect switch-n command, or
racadm connect switch -n RACADM command, or use a direct
interface to the IOM GUI to save this address to the startup configuration file.
Table 10-3. Configure I/O Module Network Settings
Item Description
Slot Indicates the location of the IOM in the chassis by group number
(A, B, or C) and slot number (1 or 2). Slot names: A1, A2, B1, B2,
C1, or C2. (The Slot value cannot be changed.)
Name Displays the IOM product name. (The IOM name cannot
be changed.)
Power State Displays the Power State of the IOM. (The Power State cannot be
changed from this page.)
DHCP Enabled Enables the IOM on the chassis to request and obtain an
IP address from the Dynamic Host Configuration Protocol (DHCP)
server automatically.
Default: Checked (enabled).
If this option is checked, the IOM retrieves IP configuration
(IP address, subnet mask, and gateway) automatically from a
DHCP server on your network.
NOTE: When this feature is enabled, the IP Address, Gateway,
and Subnet Mask property fields (located immediately adjacent
following this option) are inactivated, and any previously entered
values for these properties are ignored.
If this option is not checked, you must manually enter a valid
IP address, gateway, and subnet mask in the corresponding text
fields immediately following this option.
IP Address Specifies the IP address for the IOM network interface.
Subnet Mask Specifies the subnet mask for the IOM network interface.
Gateway Specifies the gateway for the IOM network interface.