User's Manual

Using the CMC Web Interface 183
5 Click the check box for each fabric you want to enable FlexAddress on.
To disable a fabric, click the check box to clear the selection.
NOTE: If no fabrics are selected, FlexAddress will not be enabled for the selected
slots.
The Select Slots for Chassis-Assigned WWN/MACs page displays an
Enabled check box for each slot in the chassis (1 - 16).
6 Click the Enabled check box for each slot you want to enable FlexAddress
on. If you want to select all slots, use the
Select/Deselect All check box.
To disable a slot, click the
Enabled check box to clear the selection.
NOTE: If a blade is present in the slot, it needs to be powered off before
the FlexAddress feature can be enabled on that slot.
NOTE: If no slots are selected, FlexAddress will not be enabled for the
selected fabrics.
7 Click Apply to save the changes .
For additional information, click the Help link and review "Using
FlexAddress."
Server-Level Slot FlexAddress Configuration
At the server level, you can enable or disable the FlexAddress feature
for individual slots.
Use the following steps to enable or disable an individual slot to use the
FlexAddress feature:
1
Log in to the Web interface (see "Accessing the CMC Web Interface").
2 Expand Servers in the system tree. All of the servers (1–16) appear in
the expanded
Servers list.
3 Click the server you want to view. The Server Status page displays.
4 Click the Setup tab, and the FlexAddress sub-tab. The FlexAddress Status
page is displayed.
5 Use the pull down menu for FlexAddress Enabled to make your selection;
select
Yes to enable FlexAddress or select No to disable FlexAddress.
6 Click Apply to save the changes. For additional information, click the
Help link and review "Using FlexAddress."