User's Manual

174 Using the CMC Web Interface
iDRAC Network Settings
The iDRAC Network Settings section of the Deploy iDRAC page contains a
table listing all installed server’s iDRAC IPv4 and IPv6 network configuration
settings. Using this table you can configure the iDRAC network
configurations settings for each installed server. The initial values displayed
for each of the fields are the current values read from the iDRAC. Changing a
field and clicking Apply iDRAC Network Settings saves the changed field to
the iDRAC. Follow these steps to enable and set the iDRAC Network
Settings:
1
Log in to the CMC Web interface.
2 Select Servers in the system tree.
3 Click the Setup tab.
The
Deploy iDRAC page appears.
4 Select the check box for QuickDeploy Enabled to enable the
QuickDeploy settings.
5 Set the remaining iDRAC Network Settings accordingly.
Table 5-29. iDRAC Network Settings
Setting Description
Slot Displays the slot occupied by the server in the chassis.
Slot numbers are sequential IDs, from 1 to 16 (for the 16
available slots on the chassis), that help identify the
location of the server in the chassis.
NOTE: When there are fewer than 16 servers occupying
slots, only those slots populated by servers are displayed.
Name Displays the server name of the server in each slot.
By default, the slots are named SLOT-01 to SLOT-16.
NOTE: The slot name cannot be blank or NULL.
Enable LAN Enables (checked) or disables (unchecked)
the LAN channel.
NOTE: When LAN is not selected (disabled), all other network
configuration settings, (IPMI over LAN, DHCP, IP Address
Subnet Mask and Gateway) are not used. These fields are not
accessible.