User's Manual

Using the CMC Web Interface 173

To save the selections click the

Save QuickDeploy Settings

button. If you

made changes to the iDRAC network setting, click the

Apply iDRAC

Network Settings

button to deploy the settings to the iDRAC.

To update the table to the last saved QuickDeploy settings, and restore the

iDRAC Network settings to the current values for each installed server,

click

Refresh

NOTE: Clicking the Refresh button deletes all iDRAC QuickDeploy and iDRAC

Network configuration settings that have not been saved.

The QuickDeploy feature only executes when it is enabled, and a server is

inserted in the chassis. If Set iDRAC Root Password on Server Insertion and

QuickDeploy Enabled are checked, the user is prompted using the LCD

interface to allow or not allow the password change. If there are network

configuration settings that differ from the current iDRAC settings, the user is

prompted to either accept or not accept the changes.

NOTE: When there is a LAN or LAN over IPMI difference, the user is prompted to

accept the QuickDeploy IP address setting. If the difference is the DHCP setting,

the user is prompted to accept the DHCP QuickDeploy setting.

To copy the QuickDeploy settings into the iDRAC Network Settings section,

click Auto-Populate Using QuickDeploy Settings. The QuickDeploy network

configurations settings are copied into the corresponding fields in the iDRAC

Network Configuration Settings table.

NOTE: Changes made to QuickDeploy fields are immediate, but changes made to

one or more iDRAC server network configuration settings may require a couple of

minutes to propagate from the CMC to an iDRAC. Pressing the Refresh button too

soon may display only partially correct data for one or more iDRAC servers.