User's Manual

Using the CMC Web Interface 155
NOTE: In an event of a Web server reset, wait at least one minute for the services
to become available again. A Web server reset usually happens as a result of any of
the following events: the network configuration or network security properties are
changed through the CMC Web user interface or RACADM; the Web Server port
configuration is changed through the Web user interface or RACADM; the CMC
is reset; a new SSL server certificate is uploaded.
NOTE: To modify service settings, you must have Chassis Configuration
Administrator privilege.
To configure CMC services:
1
Log in to the CMC Web interface.
2 Click the Network/Security tab.
3 Click the Services sub-tab. The Services page appears.
4 Configure the following services as required:
• CMC serial console (Table 5-21)
• Web server (Table 5-22)
• SSH (Table 5-23)
• Telnet (Table 5-24)
•Remote RACADM (Table5-25)
•SNMP (Table5-26)
• Remote Syslog (Table 5-27)
5 Click Apply; update all default time outs and maximum time out limits.
Table 5-21. CMC Serial Console Settings
Setting Description
Enabled Enables Telnet console interface on the CMC.
Default: Unchecked (disabled)
Redirect Enabled Enables the serial/text console redirection to the server
through your serial/Telnet/SSH client from the CMC.
The CMC connects to iDRAC that internally connects
to the server COM2 port.
Configuration options: Checked (enabled),
unchecked (disabled)
Default: Checked (enabled)