Quick Reference Guide

RACADM Subcommands 91
Table 2-35. setniccfg Subcommand Options
Option Description
-m <module> Specifies the module for which you want to set the IP
configuration.
<module> can be any of the following:
• server- n where n= 1–16
•
switch- n where n= 1–6
• chassis
If the -m option is excluded, the module defaults to
chassis.
-d
Enables DHCP for the Ethernet management port (default is
DHCP enabled).
-6
Displays the IPv6 information.
-s
Enables static IP settings by specifying the IP address, subnet
mask, and gateway. <ipAddress>, <netmask>, and
<gateway> must be typed as dot-separated strings.
If this option is not supplied, the existing static settings are
used.
-v
Arguments:
•< vlan id > = 1 to 4000 (1 and 4000 inclusive), 4021 to 4094
(4021 and 4094 inclusive)
•<
vlan priority > = 0 to 7 (0 and 7 inclusive)
• (no value supplied): Remove the vlan tag
-o
Disables the Ethernet management port completely.
-k
Specifies the speed and duplex for the NIC.
Arguments:
•< speed > = 10 , 100
•< duplex >= half , full
• (no value supplied): Autonegotiate